SETUP INSTRUCTIONS
1. Set up the pool by following all the instructions that came with the pool. Do not
fill with water until the Filter Pump is properly installed. Locate the
Skimmer and Inlet openings on the pool wall.
3. Remove the Seal Ring by turning it counterclockwise. Make sure to keep
the Skimmer Gasket in the proper position. (see image below)
2. Remove the Skimmer Top Cover 5 and take out the parts contained
inside.
WARNING:
CLIMBING HAZARD! PLEASE PREVENT CHILDREN FROM CLIMBING ON THE FILTER CANISTER TO GAIN ACCESS TO THE POOL.
Before assembling your product, please take a few minutes to check the contents and become familiar with all the parts.
Make sure the key
feature is facing the
correct location.
Make sure there is no gap here.
Make sure the two rubber keyways
are properly located before installation.
Inlet
opening
Skimmer opening
9
OWNER’S MANUAL
Should you encounter any problems, contact Customer Service at (888) 919-0070 from 8 AM to 5 PM Mon. thru Fri.
MST. Extended operating days and hours during peak season requirements.
4. Place the threaded intake of the skimmer through the round skimmer
opening in the pool liner and screw the seal ring
22 tightly into place.
thread slots
Make sure the pool liner is on this
round surface and does not fall into
the thread slots as this may cause
leaking.
5. Assemble the wall fitting parts according to the following schematic.
6. Final assembly should look like the following schematic.
Make sure the hose clamp
is positioned properly over
the hose and o-ring to
ensure proper seal.
canister
It is recommended to point the diverter
down and away from the suction or water
intake for optimum pool circulation.
5
5
Inside Pool Wall
Inside Pool Wall
Outside Pool Wall
Inside Pool Wall
To Next Page
Loading...
