Polypipe UFHPROGW - Setting Switching Times; Selecting Program Period; Setting ON and OFF Times

32
Setting the Switching Times
To program the switching times, follow these steps.
• Use the ‘Left/Right’ keys to scroll to ‘EDIT’ ............................................................
• Press
to conrm selection .............................................................................................
• Use the ‘Left/Right’ keys to select the day/period to program ....................
• Press
to conrm selection .............................................................................................
• Level ‘1’ will now ash and the ‘ON’ time will be displayed.
• Press
to alter Level ‘1’ ......................................................................................................
• To set the ‘ON’ time, use the ‘Up/Down’ keys to set the hours,
followed by
, then use ‘Up/Down’ to set the minutes ...........
• Press
to conrm ...............................................................................................................
• To set the ‘OFF’ time, use the ‘Up/Down’ keys to set the hours,
followed by
, then use ‘Up/Down’ to set the minutes ............
• Press
to conrm the settings .......................................................................................
• Press the ‘Right’ arrow key ..................................................................................................
• Level ‘2’ will now ash and the current settings will be displayed.
• Press
to alter Level ‘2’ settings .....................................................................................
• Repeat these steps to set all periods.
• To blank or set a switching level period to unused, rst select the switching level
then set --:-- in place of the time.
• When all switching times have been programmed use the ‘Right’ arrow
key to select ‘DONE’ and press
.............................................................................
Model: UFHPROGW