www.cuisinetechnology.com 16
In the event that electrical power is lost while your Circulator is in
use, it will begin operating automatically once power is restored,
with the temperature displayed in °F and the timer set for 24:00
hours.
Loss of Power Restart
Cleaning & Storage
Always clean and dry your Circulator completely before storing.
Be sure to protect it from contact with equipment or other objects
that could damage the digital display.
Routine Cleaning
Press to put the Circulator in Standby and then place the
Power Switch in the Off position. Unplug the power cord from the
electrical outlet.
WARNING: The unit will start automatically
after a disruption in electrical power.
!
WARNING: To avoid the potential for
burns, allow the Circulator to cool to room
temperature before removing it from the
cooking vessel.
Keeping the unit upright, wipe the housing with a clean damp
cloth or sponge. Do not use abrasive cleansers as these could
scratch the housing or LCD readout.
Should the Circulator’s immersed components become coated
with grease or other residue due to a cooking pouch leak or
break, run the unit in clean water containing a small amount
of non-sudsing dishwasher detergent for about 10 minutes at
140°F / 60°C. Rinse carefully and dry thoroughly when done.
!
CAUTION: Never immerse the Circulator’s
control or display in water or other liquids or
place under running water. Do not clean the
unit in a dishwasher.
ANY OTHER SERVICING SHOULD BE PERFORMED BY AN
AUTHORIZED SERVICE REPRESENTATIVE.
To Next Page
Loading...
Need help?
General
