TURBO
HYDRA-MA
TIC
TRANSMISSION
7E-17
Fig.
7E-28 Location
of
Case
Extension Gasket
h.
Read resulting travel or end play. Should be
.003
M
-.024
n
.
Selective washer controlling this end play is the
phenolic resin washer located
between
pump cover
and
forward clutch housing. If more or
less
washer
thickness is required to bring end play within speci-
fications,
select
proper washer from the following
chart:
Thickness
Color
.060 - .064 Yellow
.071 - .075 Blue
.082 - .086 Red
.093 - .097 Brown
.104 - .108 Green
.115 - .119
Black
.126 - .130 Purple
DIAL
INDICATOR
'
J
8001
Fig.
7E-30 Removing Front Seal
NOTE:
An oil soaked washer may tend to
dis-
color,
so it
will
be necessary to measure washer
for
its actual thickness.
REMOVAL
OF OIL
PUMP
1. If necessary to replace, pry front seal from
pump (Fig.
7E-30).
2. Remove pump attaching bolts.
3.
Install
3/8-16
threaded slide hammer adapters
J
6125-2
into bolt
holes
in pump body, attach slide
hammers J
6125-1
and remove pump assembly from
case (See Fig. 7E-31 for location of threaded holes).
4. Remove and discard pump to case seal ring
and
gasket.
Fig.
7E-29 Checking Front
Unit
End
Play
Fig.
7E-31
Removing Pump Assembly
To Next Page
Loading...
