Pontiac firebird 1968 - Page 453

7E-18
1968 PONTIAC SERVICE MANUAL
Fig. 7E-32 Removing Forward Clutch
Assembly and Turbine Shaft
5. Remove forward clutch assembly and turbine
shaft from transmission (Fig. 7E-32),
6. Remove forward clutch hub to direct clutch
housing thrust washer if it did not come out with
forward clutch housing.
7. Remove direct clutch assembly (Fig. 7E-33).
NOTE: If necessary, remove manual linkage as
follows:
a. Unthread jam nut holding detent lever to
manual shaft.
b. Remove manual shaft retaining pin from case
(Fig. 7E-34).
Fig. 7E-34 Removing Manual Shaft Retaining Pin from Case
CA UTION: Do not lose jam nut as it becomes free
from manual shaft.
c. Remove manual shaft and jam nut from case
(Fig. 7E-35).
d. Remove parking actuator rod and detent
lever assembly.
e. Remove attaching screws and parking bracket
(Fig. 7E-36).
f. Remove parking pawl return spring (Fig.
7E-37).
•
Fig. 7E-33 Removing Direct Clutch Assembly
mmm
/•
MANUAL
SHAFT
Wm
4 •
DE-mn-
4
sr. * *
Fig. 7E-35 Removing Detent Lever and
Jam Nut from Manual Shaft