TURBO HYDRA-MATIC TRANSMISSION
7E-21
*****
^CENTER
SUPPORT
BOLT
1
X
Fig.
7E-44 Removing Center Support Bolt
13.
Remove center support to case retaining snap
ring
(Fig.
7E-46).
14. Remove entire gear unit assembly by lifting
with
gear assembly installing and removing tool
J
21795
with J
6125-1
slide hammer (Fig.
7E-47).
15. Remove output shaft to case thrust washer
from
rear
of output shaft or from inside of case.
16. Place gear unit assembly, with output shaft
facing down, in
hole
in
work
bench or holding fix-
tures J 6116 and J 21364.
17. Remove
rear
unit selective washer from
transmission
case (Fig.
7E-48).
18. Remove
rear
band assembly (Fig.
7E-49).
?
BACKING
PLATE
^
COMPOS
ITS
ON
PLATES
(3)
STEEL
PLATES
(3)*
SNAP
RING
A-
Fig.
7E-46 Removing Center Support
to
Case
Snap Ring
DISASSEMBLY
OF
GEAR
UNIT
1. Remove case center support assembly (Fig.
7E-50).
2.
Remove center support to reaction
carrier
phenolic thrust washer (Fig.
7E-51).
3.
Remove center support to sun gear races and
thrust
bearing.
J
6125-1
J
21795
Fig.
7E-45 Removing
Intermediate
Backing
Plate
and
Clutch Plates
Fig.
7E-47 Removing
Case
Center Support
and
Gear
Unit
from
Case
To Next Page
Loading...
