Pontiac firebird 1968 - Page 468

TURBO HYDRA-MATIC TRANSMISSION
7E 33
FORWARD
CLUTCH HUB
^^^^^^^^^^ *
:
28
THRUST /
WASHERS -
flffpb
/
FORWARD CLUTC
HOUSING
Fig, 7E-79 Removing Forward Clutch Hub and
Thrust Washers
5. If necessary, place forward clutch and turbine
shaft in arbor press and remove turbine shaft (Fig.
7E-80).
6. Using J 4670 clutch spring compressor with
adaptor J 6129 and J 8765, compress spring retainer
and remove snap ring (Fig. 7E-81).
7. Remove snap ring, spring retainer and sixteen
(16) clutch release springs.
8. Remove forward clutch piston.
Fig. 7E-80 Removing Turbine Shaft from Forward
Clutch Housing
J 4670
RING
^^^^^^^^^^^^
J 8765 "^^pi^^^^^^^^^^p '^^lir^i
SPRING RETAINER
Fig. 7E-81 Removing Forward Clutch Spring
Retainer Snap Ring
9. Remove inner and outer clutch piston seals
(Fig. 7E-82).
10. Remove center piston seal from forward clutch
housing (Fig. 7E-83).
INSPECTION OF FORWARD CLUTCH
1. Inspect drive and driven clutch plates for signs
of burning, scoring or wear.
2. Inspect sixteen (16) springs for collapsed coils
or signs of distortion.
CLUTCH OUT-R SEAL
Fig. 7E-82 Removing Forward CI utch Piston Outer Seal