7E-34
1968
PONTIAC
SERVICE
MANUAL
FORWARD
CLUTCH
HOUSING
mJm
CLUTCH
CENTER
SEAL
Fig.
7E-83
Removing
Forward
Clutch
Center
Seal
3. Inspect clutch hubs for worn splines, proper
lubrication
holes,
thrust faces.
4. Inspect
piston
for cracks.
5. Inspect clutch housing for wear, scoring,
open
oil
passages
and free operation of ball check.
6. Inspect turbine shaft:
a.
Inspect for
open
lubrication
passages
at
each end.
b. Inspect splines for
damage.
c. Inspect ground bushing journals for
damage.
d. Inspect shaft for cracks or distortion.
NOTE:
Turbine shaft and clutch housing are
serviced
separately. Shaft may be removed from
housing by using a suitable size bolt in an arbor
press
(Fig.
7E-80).
ASSEMBLY
OF
FORWARD
CLUTCH
NOTE:
Apply automatic transmission oil to all
seals
and clutch plates before re-assembly.
1. Place new inner and
outer
oil
seals
on clutch
piston, lips
face
away from spring
pockets
(Fig.
7E-82).
FORWARD CLUTCH
ASSEMBLY
WAVED
STEEL
PLATE
FLAT
STEEL
PLATES
(4)
/
COMPOSITION
PLATES
(5)
FORWARD
CLUTCH
HUE
DIRECT
CLUTCH
HUB
SNAP
RING
•Si
THRUST
WASHERS
Fig.
7E-84
Exploded
View
of
Forward
Clutch
To Next Page
Loading...
