TURBO HYDRA-MATIC TRANSMISSION
7E-53
Fig.
7E-146 Installing
Intermediate
Backing Plate
and
Clutch
Plates
b. Mount
dial
indicator J 8001 on rod and index
with
end of output shaft.
c. Move output shaft in and out to read end
play.
End play should be from .003"-.019". The
selective washer controlling this end play is a
steel washer having 3 lugs and is located
between
thrust
washer and
rear
face of transmission case.
If
a different washer thickness is required to bring
end play within specifications, it can be selected
from
the following chart:
DIAL INDICATOR
.1
J 21904
If
t
FRONT BAND
•^4
•iP
1
v
Fig.
7E-148 Installing Front Band
Thickness
Notches and/or Stamped No.
.074 - .078
.082 - .086
.090 - .094
.098 - .102
.106 - .110
.114 - .118
None
1 Tab Side
2 Tab Side
1 Tab. O.D.
2
Tabs
O.D.
3
Tabs
O.D.
15.
Install
front band with anchor
hole
placed
over band anchor pin and apply lug facing servo
hole
(Fig.
7E-148).
V
4»
i
'4
.
Fig.
7E-147 Checking Rear
Unit
End
Play
Fig.
7E-149 Installing
Manual
Shaft
to
Case
To Next Page
Loading...
