7E-54
1968 PONTIAC SERVICE
MANUAL
16. Install manual linkage as follows:
a.
If necessary, install a new manual shaft seal
into
transmission case using a 3/4 dia. rod to
seat
the seal.
b. If removed, insert actuator rod
into
manual
detent
lever from side
opposite
pin.
c. Install actuator rod plunger under parking
bracket and over parking pawl (Fig. 7E-149).
d. Install manual shaft through case and
detent
lever.
e. Install
detent
retaining hex lock nut on manu-
al
shaft and
tighten
(Fig. 7E-150).
f. Install retaining pin, indexing with
groove
in
manual shaft. Rotate transmission to vertical
position and remove J 21795.
•Hit
•••1
it,*-
Fig.
7E-151
Installing
Direct
Clutch
17. Install direct clutch and intermediate sprag
assembly. It will be necessary to twist housing to
allow sprag outer race to index with clutch drive
plates. Housing hub will
bottom
on sun gear shaft
(Fig.
7E-151).
NOTE:
Removal of direct clutch drive and driven
plates
may be helpful.
18. Install forward clutch hub to direct clutch
housing thrust washer on forward clutch hub. Retain
with petrolatum,
19. Install forward clutch and turbine shaft, in-
dexing direct clutch hub so end of mainshaft will
bottom
on end of forward clutch hub. When forward
clutch is seated, it will be approximatley 1 1/4" from
pump face in case (Fig. 7E-152).
20. Install front pump.
21. Install all but one pump attaching
bolt
and
seal. Torque to 18 lb. ft.
NOTE:
If turbine shaft can not be rotated as pump
is
being pulled into place, forward or direct clutch
housing
has not been properly installed to index
with all clutch plates.
This
condition
must
be cor-
rected
before pump is pulled fully into place.
22. If necessary, install a new front seal, using
tool
J
21359
to drive seal in place (Fig. 7E-153).
23. Check front unit end play as
follows
(Fig.
7E-154):
MANUAL
SHAFT
KB
:N1
i.
V?
R
4i
JAM
ill!
Piiiii
••MP
JH
IMB
Fig.
7E-150
Installing
Detent
Lever
and Jam Nut to
Manual
Shaft
Fig.
7E-152
Installing
Forward
Clutch
and
Turbine
Shaft
To Next Page
Loading...
