TURBO
HYDRA-MATIC
TRANSMISSION
7E-55
Fig.
7E-153
Installing
Pump
Seal
a. Install a
5/16"-18
threaded slide hammer
or J 6125 into bolt
hole
in pump.
b. Mount a dial indicator on rod and index in-
dicator to register with end of turbine shaft.
c. Push turbine shaft
rearward.
d.
Pull
output shaft forward.
e. Set dial indicator to zero.
f.
Pull
turbine shaft forward.
Read
resulting travel or end play - should be
.003" to .024". Selective washer controlling this end
play is phenolic resin washer located
between
pump
cover and forward clutch housing. If more or
less
washer thickness is required to bring end play within
specifications,
select
proper washer from the chart
below:
Thickness
(in
inches)
Color
.060-.064
Yellow
.071-.075
Blue
.082-.086
Red
.093-.097
Brown
.104-.108
Green
.115-.119
Black
.126-.130
Purple
NOTE:
An oil
soaked
washer
may
tend
to
dis-
color.
It
will
be
necessary
to
measure
washer
for
its
actual
thickness.
24. Install remaining front pump attaching bolt and
seal. Torque 18 lb. ft.
REAR
EXTENSION
HOUSING
ASSEMBLY
Fig.
7E-154
Checking
Front
Unit
End
Play
2. Attach extension housing to case, using attaching
bolts. Torque
bolts
to 22 lb. ft.
3.
If necessary, install new seal with
tool
J
21359
(Fig.
7E-155).
1. Install extension housing to case gasket on
extension housing.
Fig.
7E-155
Installing
Rear
Extension
Seal
To Next Page
Loading...
