Pontiac firebird 1968 - Page 692

ACCESSORIES 15-7
SEALING RIDGE
(DO NOT SCRATCH OR DENT)
FILTER PLATE FILTER
CAUTION: DO NOT LOOSEN OR REMOVE-
FACTORY ADJUSTED
•MM
POINT ADJUSTING
SCREW
\
LOW SPEED
SWITCH
Fig. 15-6 Adjusting Low Speed Switch
Fig. 15-5 Cover and Intake Filter Assembly
DISASSEMBLY (Fig. 15-5)
NOTE: Do not tamper with the following screws
(Fig. 15-6).
1. Vacuum restriction screw in the regulator housing.
2. The screw in the bearing support assembly.
3. The screw on top of the solenoid coil.
These screws are pre-adjusted at the factory.
Fig. 15-7 Bearing Support—Removal