POOLEX Nano - Heating Mode Operation

17
Useful information about how the heating mode operates
When the incoming water temperature is less than or equal to the required temperature (setpoint tempera-
ture) -X°C, the heat pump will switch to heating mode. The compressor will stop when the temperature of
the incoming water is greater than or equal to the required temperature (setpoint temperature).
Indicators for adjustment range X and Y
X : adjustable parameter from 1° to 15°C, default setting is 3°C. (Parameter N°6)
Step 1 : Press to switch on your pump.
Step 2 : Using buttons and select the required temperature.
EXAMPLE:
If the current temperature is 15°C, default setting temperature is 27° required temperature is 30°C.
4. Use
4.2 Heating Mode
Current water
temperature
Required
temperature
WARNING: Before starting, ensure that the ltration pump is operating correctly.