Part III Basic Stitch
Straight stitch
Selection of stitch A, B, C
Thread tension dial 2~6
Presser Z-presser
Starting sewing
Lift the presser, place the fabric beneath presser and align it
with the guide on needle plate, place the needle on the sewing
start position, pull the top thread and bottom thread to back,
lower the presser, press the pedal controller and start sewing
along the guide.
Note:
For general sewing, leave 1.6 cm sewing allowance.
Reinforcing sewing
Press the reverse sewing button to backwards stitch several
needles and then resume forwards sewing.
Rectangular-corner
On fabric margin, leave 1.6 cm rectangular-corner.
1. When sewing at the corner, stop sewing.
2. Rotate hand wheel towards the operator to lower needle.
3. Lift the presser and rotate the fabric to 1.6 cm guide.
4. Lower
the presser and start sewing as the new direction.
1
2
3
11
To Next Page
Loading...
