2.
2.
3.
5.
6.
7.
8.
3. Winding bobbin
1. After outwards pulling the hand wheel to release clutch,
during winding bobbin the needle will be impossible to move.
Pull out the spool holder on back of machine, place \felt pads
and insert the doubling spindle into spool holder with thread
direction shown in diagram.
Spool holder
Felt pad
Clew
Hand wheel
T
Bobbin winding thread guide
hread guide
2. Pass thread from spool through thread guide as shown.
3. Wind the thread around bobbin winding thread guide.
4. Place the bobbin on winding shaft and pass the bottom
thread through the small hole of bobbin outwards from inside.
5. Push the winding shaft rightwards.
6. Hold the thread end with hand and start the machine. After
winding some bottom thread round the bobbin, stop the
machine and cut off the thread end near small hole of bobbin.
7. Restart the machine. After full winding of the bobbin, it will
automatically stop. At that time, stop the machine, leftwards
push winding shaft to its original position and cut off thread.
8. Leftwards push hand wheel to close clutch.
5
6
6
To Next Page
Loading...
