PORA PR-DTC-3000 User Manual

6
PORA ELECTRIC MACHINERY CO.,LTD.
Taper Tension Controller
2) Arrangement of the Terminals
Terminal pad
PR-DTC-3000
'(
2 3 4
7 8 9
2 3 4 45 5
1518 1417 1316
5
10
4
12
5
11
1
2
2
3
3
4
4
5
5
6
PR-DTC-3000P
'(
2 3 4
7 8 9
2 3 4 45 5
1518 1417 1316
5
10
4
12
5
11
1
2
2
3
3
4
4
5
5
6
1SPYJNJUZTFOTPS
13%/
7  4*((/%
5 5
10
4
1211
Proximity sensor connecting terminal
※ To attain the perfect compatibility with the controller, make sure to use the cylinder-type proximity sensor by Autonics.
(And also, the 24V NPN or PNP type sensor)
Due to the potential risks of malfunctioning and damages to the unit, make sure to check the above
terminals and match their respective colors.
Precaution
: Check the sensor connecting terminals
- Use crimp-style terminals being equal the figure below in size.
- Be sure to fasten terminals tightly so that they would not be a cause of malfunctions.
- Do not install input/output wires through the same duct with other power lines, and do not bind them together.
- The pulse input wire to the roller shaft should be grounded using a shield wire from signal receiver.
.
NN
NN
#FDBSFGVMPG
QPXFSFMFDUSJDXJSJOH
#FDBSFGVMPG
QPXFSFMFDUSJDXJSJOH

PORA PR-DTC-3000 Specifications

General

Brand	PORA
Model	PR-DTC-3000
Category	Controller
Language	English