INSTALLATION GUIDE
ADJUSTING THE MECHANICAL DOORSTOP
§ CAUTION – DO NOT REMOVE THE STOPS
§ IMPORTANT - This step may be optional depending on your application
§ The mechanical stops are located on the top or bottom of the operator, depending on the hand of the door.
§ Apply 120 VAC Main power to the control
o Place the On-Off-Hold switch to
the Hold Open position
OPEN ROTATION
STOP POINT SCREW
(MOVES WITH OPERATOR ROTATION)
CLOSED DOOR STOP
OPEN DOOR STOP
WWW.PORTALP.COM | 29
Automatic Doors & Building Access Control
SW10 (Full Power) & SW19 (Low Energy)
To Next Page
Loading...