Portalp SW19 - Product Description & Specifications

INSTALLATION GUIDE
PRODUCT DESCRIPTION & SPECIFICATIONS
Po
wer Supply*
115
VAC (+6%, -10%) 60Hz with ground
Po
wer Consumption
100
W
C
urrent Consumption
1
A
M
otor
24
VDC Permanent Magnet with Belt Driven Encoder
H
eader Dimensions
4
1/2”
Height x 4
7/8”
Depth
F
used Protection
3
.5A Fuse (F1 located on I/O Board)
W
eight
32
lbs – 65 lbs Per Operator Assembly
Am
bient Operating Temperature**
-
4 to 131º F
I
ngress Protection
I
P23 (protection from spray water up to 60º from the vertical - ie. Rainstorm)
M
aximum Door Weight
P
USH ARM PULL ARM
36
” Door:438 lbs 342 lbs
42
” Door:328 lbs 256 lbs
44
” Door:299 lbs 234 lbs
48
” Door:254 lbs 198 lbs
24
VDC Accessories Power Supply
24
VDC / I A. Max
24
VDC Electric Lock Power Supply
24
VDC / I A. Max
A
djustable Speeds & Timers
O
pening Speed, Closing Speed, Hold Open Time,
Closing
Speed with power off
S
tandard Selector Switch Functions
A
utomatic, Hold Open, Manual (Off)
S
tandard Control Outputs • Malfunction Alarm Signal
• Electric Lock Relay
• 24 VDC Accessories Power Supply
• Door Status
S
tandard Control Inputs
I
nterior Activation, Exterior Activation, Emergency Shutdown,
Al
arm Output, “Stop” Safety Device (door-mounted),
S
afety Device Input, Secondary Activation
Qu
ick Disconnects
T
AP-Controller (optional)
* This product should only be connected to an electrical installation that complies with the regulations.
** The installer must ensure that the temperature range marked on the nameplate is well suited to the site.
Before any work is carried out, please comply with the size (width,
weight) specified in the Technical Characteristics. If instructions
are not followed, this may seriously affect the function of the
operator. The manufacturer is not responsible if the operator is
used outside of the scope of its application or contrary to the
assembly instructions.
Avant tout travail, veuillez respecter les dimensions (largeur, poids)
spécifiées dans les caractéristiques techniques. Si les instructions ne
sont pas respectées, cela peut affecter gravement le fonctionnement
de l'opérateur. Le fabricant n'est pas responsable si l'opérateur est
utilisé en dehors du domaine d'application de son application ou
contrairement aux instructions de montage.
WWW.PORTALP.COM | 6
Automatic Doors & Building Access Control
SW10 (Full Power) & SW19 (Low Energy)