PROBLEM
Knocking Noise.
CAUSE
Possible defect in safety
valve.
Defective check valve.
Loose pulley.
Loose flywheel.
Compressor mounting
screws loose.
Loose belt.
Carbon build-up in pump.
Belt to tight.
CORRECTION
Operate safety valve manually
by pulling on ring. If valve still
leaks, it should be replaced.
Remove and clean, or replace.
Tighten pulley set screw,
see Parts manual for torque
specifications.
Tighten flywheel screw, see
Parts manual for torque
specifications.
Tighten mounting screws,see
Parts manual for torque
specifications.
Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Have checked by a Trained
Service Technician.
Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Excessive belt Loose belt. Loosen wingnut and then
wear. tighten wingnut until it contacts
Tight belt.
Loose pulley.
Pulley misalignment.
Compressor pump has no
oil.
Loose belt.
Squealing
sound.
the washer, plus one turn.
Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
Have checked by a Trained
Service Technician.
See Motor Pulley/Flywheel
Alignment paragraph in the
Maintenance section.
See Oil-Checking paragraph in
the Maintenance section.
Loosen wingnut and then
tighten wingnut until it contacts
the washer, plus one turn.
27- ENG A10260
To Next Page
Loading...
