Porter-Cable PCC620 - Page 4

4
limit daily time of use.
• Keep your hair, clothing, and gloves
away from air vents. Air vents often
cover moving parts in which these items
can be caught.
• Hammer bits and tools get hot during
operation. Wear gloves when touching them.
•Hold tool firmly with two hands,
one hand on the handle, and the other
gripping the bottom around the battery
area or the auxiliary handle if provided.
Loss of control can cause personal injury.
•When not in use, place tool on its side
on a stable surface where it will not
cause a tripping or falling hazard. Some
tools with large battery packs will stand
upright but may be easily knocked over.
• Wear safety goggles or other eye
protection. Hammering and drilling
operations cause chips to fly. Flying
particles can cause permanent eye
damage. Everyday eyeglasses are NOT
safety glasses. Also use face or dust mask
if drilling operation is dusty.
ALWAYS WEAR CERTIFIED SAFETY
EQUIPMENT:
 •ANSIZ87.1eyeprotection(CAN/CPA
Z94.3),
•ANSIS12.6(S3.19)hearingprotection,
•NOSH/OSHArespiratoryprotection.
WARNING: Some dust created by
power sanding, sawing, grinding,
drilling, and other construction activities
contains chemicals known to the state
of California to cause cancer, birth
defects or other reproductive harm.
Some examples of these chemicals are:
• lead from lead-based paints,
 • crystalline silica from bricks and cement
and other masonry products, and
• arsenic and chromium from
chemically-treated lumber.
Your risk from these exposures varies,
depending on how often you do this type
of work. To reduce your exposure to these
chemicals: work in a well ventilated area,
and work with approved safety equipment,
such as those dust masks that are specially
designed to filter out microscopic particles.
• Avoid prolonged contact with
dust from power sanding, sawing,
grinding, drilling, and other
construction activities. Wear
protective clothing and wash exposed
areas with soap and water. Allowing
dust to get into your mouth, eyes, or lay
on the skin may promote absorption of
harmful chemicals.
WARNING: Use of this tool can
generate and/or disperse dust, which
may cause serious and permanent
respiratory or other injury. Always use
NOSH/OSHA approved respiratory
protection appropriate for the dust exposure.
Direct particles away from face and body.
Symbols
The label on your tool may include the
following symbols. The symbols and their
definitions are as follows:
V ..................volts
A ..................amperes
Hz ................hertz
W .................watts
min ..............minutes
or AC ...... alternating current
or DC ...direct current
n
o ................no load speed
................Class I Construction
................earthing terminal
(grounded)
...............safety alert symbol
................Class II Construction
(double insulated)
.../min or rpm...revolutions or
reciprocation per minute
..............Read instruction manual
before use
................Use proper respiratory
protection
...............Use proper eye protection
................Use proper hearing
protection
BPM ...........beats per minute
• Whenusinganextensioncord,be
sure to use one heavy enough to carry
the current your product will draw. An
undersized cord will cause a drop in line
voltage resulting in loss of power and
overheating. The following table shows
the correct size to use depending on
cord length and nameplate ampere
rating.Ifindoubt,usethenextheavier
gage. The smaller the gage number, the
heavier the cord.
Recommended Minimum Wire Size for Extension Cords
Total Length of Cord
25ft. 50ft. 75ft. 100ft. 125ft. 150ft. 175ft.
7.6m 15.2m 22.9m 30.5m 38.1m 45.7m 53.3m
Wire Size AWG
18 18 16 16 14 14 12