PP6000 Command Details - Page 6
n = 4: Continuous paper sensor status
Bit
Off/On
Hex Decimal
Function
0 Off 00 0 Not used. Fixed to Off
1 On 02 2 Not used. Fixed to On
Off 00 0 Paper roll near-end sensor: paper adequate 2,3
On 0C 12 Paper roll near-end sensor: paper near-end
4 On 10 16 Not used. Fixed to On
Off 00 0 Paper end sensor: paper present 5,6
On 60 96 Paper end sensor: paper end
7 Off 00 0 Not used. Fixed to Off
CODES
(HEX/CONTROL):
<10> <05> <n>/ {DLE} {ENQ} n
NAME:
Real-time request to printer
FUNCTION:
Request to printer in real-time
RANGE:
1 ≤ n ≤ 2
EXPLANATION:
1. The parameter n specifies content according to the printer status as below:
n =1 Recover from an error and restart printing from the line where the error
occurred.
n = 2 Recover from an error aft clearing the receive and print buffers.
2. This command is effective only when an auto-cutter error occurs.
3. This printer starts processing data upon receiving this command.
4. This command executes with a serial interface model even when the printer is off-
line, when the receive buffer is full, or when there is an error status.
5. With a parallel interface model, when DIP switch position 4 (or 1 - 4) is set to
OFF this command can only be executed when the printer is under normal status
(on line, no error, not busy). When DIP switch position 4 (or 1 – 4) is set to ON,
this command can not be executed when the printer is busy but can be executed
when the printer is off-line or there is an error status
To Next Page
Loading...
