Aircraft status indicator
No.
1 Aircraft 2.4GHz disconnected.
2
Aircraft is in initialization detection status.
3
No GPS signal, aircraft is in gesture mode.
4
Front light glows solid red, rear
light glows solid green.
Good GPS signal, aircraft is preparing
for GPS mode.
5
Aircraft is in gyroscope calibration status.
6
Aircraft is in compass horizontal calibration.
7
Front and rear lights flash green alternatively. Aircraft is in compass vertical calibration.
8
Front light glows solid red, rear light
flashes red slowly.
Aircraft is nearly low voltage, 1/4
battery level left.
9
Front light glows solid red, rear light
flashes red rapidly.
Aircraft is in low voltage, only 1/6
voltage left.
10
Front and rear lights flash once, stop
for 1.5 second.
Something wrong with the gyroscope.
11
Front and rear lights flash twice, stop
for 1.5 second.
Something wrong with the barometer.
12
Front and rear lights flash three times, stop
for 1.5 second.
Something wrong with the compass.
13
Front and rear lights flash fourth times, stop
for 1.5 second.
Something wrong with the GPS module.
Indicator status Meanings
Front and rear lights flash yellow rapidly.
Front and rear lights flash red, green and
yellow alternatively.
Front lights glow solid red, rear lights glow
solid yellow.
Front and rear lights flash green rapidly.
Front and rear lights flash yellow alternatively.
Aircraft initialization detection
After signal connection, the aircraft enters into initialization detection procedure with front and rear
lights flashing red, green and yellow alternatively. Make sure that the aircraft is set on a flat and still
surface for the initialization detection. The aircraft initialization detection takes about 8 seconds. Once
the remote controller sends out "Di Di" sounds and the aircraft front and rear lights flash yellow
alternatively, initialization detection is completed.
!
Attention: Make sure that the aircraft is set on a flat and still surface for the initialization
detection.
-12-
To Next Page
Loading...
