The CNC installation folder has been changed. Formerly, every-
thing had been installed in c:\program files\power automation.
In Windows 7 (W7) it is installed under c:\pacnc. This is also true
for the files, which are written from the CNC software on
d:\ partition.
So there is also a folder called d:\pacnc for the files, which are
written from the CNC during runtime. Everything below c:\pacnc
and d:\pacnc is the same as before below
c:\program files\power automation and
d:\program files\power automation. For compatibility reasons,
the folders remain c:\program files\powerautomation and
d:\program files\power automation for Windows XP systems.
The PA standard HMI is fully compatible. Also every User-HMI,
which is based on HTML will run without problems. User-HMIs,
based on own code (scripts, C, Java or ActiveX) must be tested by
the customer itself.
The usage of compile cycles is the same as before.
Old CNC/HMI Backups cannot be used in the current version of
3.5.x, because of the changed installation path. There will be a
future version, which will allow to restore old backups to the new
installation paths.
The material warranty seals affixed to the control unit at various
positions ensure that the control unit's casing is not opened by
unauthorized persons.
Broken or removed seals void all material warranty
provided by Power Automation.
– Never open the control unit, or you will lose your
material warranty.
– Always contact Power Automation, if extensions,
repairs or modifications are required (see
Ä
Chapter 9 “Service and return process”
on page 95).
New CNC Installation Folder
Compatibility To CNC Versions
Before 3.5.x
Material Warranty Seals
PA 8000 EL CNC control unit
Safety
24.09.2015 | 25
To Next Page
Loading...
Need help?
General
