1 General information
1.1 Information on this manual
This installation manual provides important information on how to
work with the control unit safely and efficiently.
The installation manual is part of the control unit, must always be
kept in the control unit's direct proximity and should be available for
the personnel at any time. All personnel working with the control
unit are obliged to have read and understood this installation
manual before starting any work. Strict compliance with all speci-
fied safety notes and instructions is a basic requirement for safety
at work.
Moreover, the accident prevention guidelines and general safety
regulations applicable at the place of use of the control unit must
also be complied with.
Illustrations in this installation manual are intended to facilitate
basic understanding, and may differ from the actual design of the
control unit.
The enclosed manuals for the installed components apply together
with this installation manual.
1.2 Explanation of symbols
Warnings are identified by pictures. These warnings are introduced
by signal words, which express the severity of a danger.
Pay attention to these warnings and act cautiously in order to avoid
accidents, personal injuries and damage to property.
DANGER!
… indicates an imminently hazardous situation which,
if unavoidable, will result in death or serious injury.
WARNING!
… indicates a potentially hazardous situation which, if
unavoidable, could result in death or serious injury.
CAUTION!
… indicates a potentially hazardous situation which, if
unavoidable, may result in minor or moderate injury.
NOTICE!
… indicates a potentially hazardous situation which, if
unavoidable, may result in property damage.
General Information
Warnings
PA 8000 EL CNC control unit
General information
24.09.2015 | 7
To Next Page
Loading...
Need help?
General
