EasyManua.ls Logo

Power-Pole Charge - Maintanence & STORAGE

Power-Pole Charge
24 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
18 | CHARGE Installation & Owner’s Guide
Maintanence & STORAGE
Your boat’s electrical system and CHARGE™ unit must be properly maintained to ensure peak performance
and safe operation. Here is a list of recommended maintanence procedures:
General Maintenance
Always wear appropriate safety gear such as gloves and glasses.
Follow battery manufacturer’s maintenance instructions.
Inspect all battery connections. If loose, tighten battery connections.
Check terminals for dirt, oil and battery corrosion. If dirty, clean terminals using a water and baking soda solution. Dry
with a clean cloth. Be sure to follow directions specific to your battery manufacturer when cleaning.
Check wires to see if any cuts or abrasions exist. Contact JL Marine Systems Inc. at 1+(813) 689-9932 option 2 if any
wire damage is found. Damaged cords can cause electric shock or electrocution.
Inspect all batteries for any visible damage. This can include punctures, swelling, or warping of the
batteries.
Always store CHARGE™ in a clean, dry, well ventilated area.
For Customer service, please call 1+(813) 689-9932 option 2.
Q: What battery types is the CHARGE™ compatible with?
A: The Charge is compatible with all battery types: Lead Acid, GEL, AGM, TPPL and Lithium-Ion.
Q: Can the CHARGE™ recharge batteries on its own?
A: The CHARGE™ is not a power source. It can only charge via AC power or the alternator when running your motor.
Q: Can I change the minimum battery settings?
A: Yes. However, the CHARGE™ is already set at optimum minimum battery settings.
Q: Is the CHARGE waterproof?
A: The CHARGE™ is splashproof. We strongly recommend mounting the CHARGE™ in a dry area. However, it will have
no problem handling minor splashes.
Q: What safety features are built into the CHARGE™?
A: The CHARGE™ has several features to protect both your boats wiring and batteries. These include: reverse polarity
protection for each battery, low voltage and overvoltage protection, over current protection on all output channels,
temperature sensors based on battery chemistry, and short-circuit protection.
Q: How much power does the CHARGE™ deliver?
A: The CHARGE™ delivers 500 watts of power for fast recovery time.
Q: How many amps does the power deliver to each battery?
A: The CHARGE™ delivers a max of 40 amps to the engine battery and a max of 25 amps to the trolling motor batteries.
FAQ’S