Istruzioni per l’uso e manutenzione
Cod. OQ7.5ARG114 – GB
Emiss. 19-01-11 Rev. 0 - Agg. /
20
POWER SYSTEM SRL
Via dell’Emigrante, 11/13 - 36040 Brendola (VI) Italia
9 UNPACKING AND HANDLING
The compressor should be lifted only with a pallet truck or a fork lift truck with suitable lifting capacity.
• Check the integrity of the packaging.
• Unpack the machine (paying attention to any indications on the packaging).
• Check the (outer) good condition of the machine.
• Open the access doors and check all inner parts (visual check).
• Dispose of the packing in compliance with the current waste disposal regulations.
IF ANY FAULTS ARE FOUND IT IS FORBIDDEN TO USE THE COMPRESSOR. YOU MUST APPLY TO
YOUR DEALER OR TO THE MANUFACTURER FOR TECHNICAL ASSISTANCE.
IT IS RECOMMENDED TO DISPOSE OF THE PACKAGING ACCORDING TO THE DIFFERENT TYPES
OF MATERIAL, ABSOLUTELY RESPECTING THE LAWS IN FORCE IN THE COUNTRY OF USE.
THE MACHINE PACKAGING MUST BE LIFTED WITH A FORK-LIFT TRUCK (SUITABLE FOR THE
USE), RESPECTING THE INSTRUCTIONS APPLIED ON THE OUTSIDE OF THE PACKAGING.
Proceed as follows:
1) Open and remove the cardboard using a suitable tool
2) Remove any screws securing the compressor to the pallet
3) Get into position on the longest side and insert the forks of the suitable fork-lift truck under the compressor or the reservoir,
until they come out on the opposite side.
4) Carefully lift the load and carry it to the place of use.
5) Lower the load very carefully until it is completely resting on the ground.
6) Extract the forks of the fork-lift truck from under the compressor or reservoir.
9.1 LIFTING AND HANDLING THE MACHINE
The compressor must be transported and handled only as shown in the following figure, with a pallet truck or a fork lift truck.
LIFT THE COMPRESSOR ONLY BY THE BASE; DO NOT TRY TO LIFT IT BY OTHER PARTS SUCH
AS THE CANOPY, MOTOR, PIPES AND SO ON.
PROTECT THE COMPRESSOR CANOPY WITH A CARDBOARD BOX
Fig.5
To Next Page
Loading...