Istruzioni per l’uso e manutenzione
Cod. OQ7.5ARG114 – GB
Emiss. 19-01-11 Rev. 0 - Agg. /
52
POWER SYSTEM SRL
Via dell’Emigrante, 11/13 - 36040 Brendola (VI) Italia
29 REGISTRATION AND COMMISSIONING REPORT
ISSUING DATE
Power System S.r.l. REGISTRATION AND SETTING
REPORT
SERIAL
NUMBER
service department
Ref:
OQ7.5CRG28
Page:
Distributor Customer
Compressor Model Date of installation
Serial Number
Year of manufacture
INSTALLATION
1 Location (compressors room, department, outside, etc.. ..)
2 Atmosphere (dirty, dusty, humid, closed, etc. ..)
3 Ambient temperature with unit working (°C)
4 Kind of installation (compressor, receiver, dryer, filters, etc…)
SETTING
5 Check oil level OK NO OK
6 Check tightening of all electric components OK NO OK
7 Check power feed:
a) check voltage ± 10% (Volt) instrument
b) check voltage auxiliary circuit ± 10% (Volt) instrument
8 Check correct direction of rotation: OK NO OK
a) check load current (Amp)
(verify with test certificate)
b) check overloads protection adjustment (motor – fan)
9 Check right operation of electronic panel OK NO OK
10 Operate the compressor at max temperature and check after 30 seconds:
a) Check air leaks YES NO
b) Check oil leaks YES NO
c) Check regular return on oil recovery of separator YES NO
d) Check load and no load pressure (bar Load) (bar no-Load)
e) Check oil temperature (°C) At ambient temperature (°C)
f) Check oil level YES NO
HANDOVER OF DOCUMENTS AND INFO TO CUSTOMER
a) explanation of start up/shut down procedure YES NO
b) explanation of Service responsibility YES NO
c) inquiry of check scheduled service YES NO
d) Handover of :
1) Cabinet key YES NO
2) Instruction manual YES NO
3) Spare parts manual YES NO
4) Copy of this report YES NO
5) CE Certificate YES NO
Notes:
Customer
Signature
Technicien Signature
To Next Page
Loading...