20
– This rear roller cylinder mower is fitted with a non-rewireable
plug. If it is necessary to change the fuse in the plug or the
fuse cover becomes loose or damaged, the plug must not be
used until a suitable replacement is obtained. A 13amp fuse
must be fitted.
1. Make sure the on/off switch is in its off position.
2. Double the extension cord about a foot from the end, and push
the loop through the hole on the rear safe guard and hook the
loop over the cord restrainer. Gently pull on the cord to ensure
that it is firmly attached at the handle.
3. Connect the cord to a suitable socket.
To Next Page
Loading...
