21
Preparing to Operate the Mower
1
2
This cylinder mower can be set to 3 positions of cutting height.
Position 3 is the lowest cutting height.
1. Pull the lever outwards from the machine and then select your
required cutting height position, for example 1, 2, or 3.
2. Release the lever and then make sure that it is fully secured
into the selected cutting position.
Note: Never use the lowest cutting height for the first cut of the
season or in drought conditions.
Cutting position Cutting height
1 18mm
2 28mm
3 38mm
Preparing to operate the rear roller cylinder
mower
Always wear safety gloves when doing any work on the rear
roller cylinder mower.
WARNING! Always unplug the power cord from the power
source before doing any work on the rear roller cylinder
mower.
Step 1 - Adjusting the cutting height
To Next Page
Loading...
