14 PowerBox-Systems − World Leaders in RC Power Supply Systems
Once you have assigned the Gain control, press Continue to conrm your choice.
If no iGyro SAT is connected, this concludes the Setup Assistant.
If an iGyro SAT is connected, the next step is to establish the installed orientation
of the iGyro SAT:
This is accomplished by moving the model in the directions shown in the graphic
display: rst move the tail of the model up and down two or three times. You will
see that the elevators follow this movement every time - the direction of effect is
not important at this stage.
At the end of the movement hold the model’s tail up and wait until the elevators
return to neutral (centre).
Now repeat the procedure with the rudder (yaw) axis: move the tail to left and right
two or three times – then hold the tail to the right until the rudder returns to neutral.
The Assistant now continues to the process of establishing the directions of effect
(“sense”) and learning the transmitter control end-points. Before you carry out this
procedure, it is essential to set the direction of effect and the end-points of the pri-
mary functions at the transmitter.
Note: This procedure can be awkward to carry out with larger models. However,
there is a simple trick which makes learning the installed position easier: don’t x
the iGyro SAT in the model until after the learning process is complete. During
the learning procedure you simply move the iGyro SAT in the appropriate direc-
tion, rather than the model itself!
To Next Page
Loading...
