www.powerbox-systems.com 15
In this menu the system learns the aileron, elevator and rudder sticks as you hold
each stick in the direction shown on the screen, and press the SET- button.
The Setup Assistant is now nished, but you can still assign additional outputs ma-
nually, carry out the Door Sequencer Assistant, or match multiple servos.
-
7.SERVO MATCHING
The Servo Matching function can be used to adjust all 16 outputs in travel and di-
rection using ve points. Its purpose is to match the travels of multiple servos which
are mechanically interconnected, or which control multiple functions using only a
single channel. For example, the rudder may be coupled to a steerable nosewheel.
Servo matching is divided up over three screen displays: in the rst you select the
output which is to be adjusted; in the second the output is initialised; in the third
display the servo is adjusted.
In the initial Servo Matching screen you should select the output which you wish to
adjust. At this point you can also reverse the output with a button-press, or move
on to Auto-Matching.
Note: At any time, you can repeat the procedure in the Gyro menu for setting the
direction of effect and the end-points. This is absolutely essential in any case if
you adjust the travels or directions of effect of the primary functions while you
are setting up the model.
Note: In contrast to earlier versions of the PowerBox Assistant, it is now pos-
sible to repeat the Setup Assistant at any time. The system retains previously
entered settings, and only overwrites the entries you have changed.
To Next Page
Loading...
