www.powerbox-systems.com 9
4. MAIN MENU
To access the menu you need to hold the SET button pressed in for about 2 - 3 se-
conds, after which you can select the desired menu using buttons I and II.
Press the SET button once you have selected a menu point. You can now alter the
values and settings using buttons I and II.
The “Rotary Menu” shown above contains the following sub-menus:
• iGyro
Here you will nd all the settings relating to the iGyro. These features are only
available if an iGyroSAT is connected to the unit.
• ServoMatching
If you have servos which are mechanically inter-connected, you can use this sub-
menu to adjust them to match each other using a ve-point curve. You will also
nd the Auto Matching function here.
• Sequenzer
At this point you can set up the door sequencer, either manually or with the help
of the Assistant.
• Output Mapping
In this menu you can assign all 16 outputs directly to any transmitter channel, to
a Gyro output or the door sequencer.
• Input Mapping
The transmitter channels are assigned to the iGyro or sequencer here.
To Next Page
Loading...
Need help?
General
