15 2000Wi OM
4.4 Generator use
Be sure to ground the generator when loads are connected.
To prevent electrical shock from faulty appliances, the generator should be grounded.
Connect a length of heavy cable between the generator's ground terminal and an
external ground source.
Connections for standby power to a building's electrical system must be made by a
qualified electrician and must comply with all applicable laws and electrical codes.
Improper connections can allow electrical current from the generator to back feed into
the utility lines. Such back feed may electrocute utility company workers or others who
contact the lines during a power outage. When utility power is restored, the generator
may explode, burn, or cause fires in the building's electrical system.
Do not connect the generator to an automatic transfer device. Severe damage to the
inverter module may result.
Indoor use of a generator can kill quickly. Generators should be used outdoors only.
The total wattage of all appliances connected must be considered.
Do not exceed the current limit specified for any one receptacle.
Do not connect the generator to a household circuit. This could cause damage to the
generator or to electrical appliances in the house.
Do not modify this generator or use it for purposes other than its intended use.
Do not connect an extension to the exhaust pipe.
When an extension cord is required, be sure to use a rubber sheathed flexible cord.
Also make sure to use the proper size and length cord.
16 Gauge Cords - a 16 gauge cord between 0 and 100 feet long will safely
handle tool and appliance loads up to 10 amps.
14 Gauge Cords - a 14 gauge cord between 0 and 50 feet long will safely handle
tool and appliance loads between 10 and 15 amps.
12 Gauge Cords – a 12 gauge cord between 50 and 100 feet will safely handle
tool and appliance loads between 10 and 15 amps.
Keep the generator away from other electric cables or wires such as commercial power
supply lines.
The DC receptacle can be used while the AC power is in use. If you use both at the same
time, be sure not to exceed the total power for AC and DC.
Most appliance motors require more than their rated wattage for start-up.