EasyManua.ls Logo

Powerhouse 2000Wi - SPARK ARRESTOR MAINTENANCE; Spark Arrestor Cleaning Procedure

Powerhouse 2000Wi
40 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28 2000Wi OM
5.6 Spark arrestor maintenance
If the generator has been running, the muffler will be very hot. Allow it to cool before
proceeding.
The spark arrestor must be serviced every 100 hours to maintain its efficiency, or a
decrease in horsepower may occur.
Because of the size of the spark arrester opening in the exhaust grill you may decide that
you do not want to take off the grill. This will not cause an issue unless you drop the
arrester or the clamp or screws behind the grill. Taking the grill off or leaving it on is a
matter of your convenience, but the procedure below will include removing the grill.
1. Remove the six M6 screws and remove the muffler grill.
2. Remove the two M4 screws holding the spark arrester to the muffler.
3. Use a stiff wire brush to remove carbon deposits from the spark arrester screen.
4. Inspect the screen for holes, and replace it if necessary.
5. Reinstall the spark arrester.
6. Reinstall the muffler grill.
Muffler Grill
M6 Screws
Spark Arrestor
M4 Screws

Other manuals for Powerhouse 2000Wi

Related product manuals