27 2000Wi OM
9. Install the spark plug carefully, by hand, to avoid cross-threading.
10. After a new spark plug has been seated by hand, it should be tightened 1/2 turn with a wrench to compress
its washer. If a used plug is being reinstalled, it should only require 1/8 to 1/4 turn after being seated.
11. Reinstall the spark plug cap on the spark plug securely.
12. Reinstall the spark plug maintenance cover.
The spark plug must be securely tightened. An improperly tightened plug can become
very hot and possibly damage the generator.
Never use a spark plug with an improper heat range.
Always use an A7RTC resistor-type spark plug. Using a non-resistor spark plug will
interfere with AC output and the electronics, and may prevent the engine from starting.
To Next Page
Loading...
