Powermat PM0748 - Preliminary Steps; How to Use the Device; Battery Charging; Installing the Battery

PRELIMINARY STEPS
a) Open the package, then take out the device.
b) Remove the protective foil and transport protection (if any).
c) Check that the machine and accessories have not been damaged during transport.
d) Retain the packaging.
ATTENTION! The device and packaging are not for fun! Keep out of the reach of children, risk of
swallowing or suffocation.
OPERATING THE DEVICE
Before connecting the device to the mains, make sure that its parameters correspond to the
parameters given on the rating plate of the device. Do not connect the device to the mains with
higher voltage than required by the device, it may cause electric shock and damage the device.
Connecting to the mains with a lower voltage may damage the appliance's motor.
ŁCHARGING THE BATTERY
Before connecting the charger to the mains, make sure that its parameters correspond to the
parameters given on the rating plate. Do not connect the charger to the mains with a voltage
higher than required, it may cause electric shock and damage the device. Connecting to a lower
voltage network may damage the charger or the battery.
ATTENTION! Only charge the batteries on a flat, stable, non-flammable surface, away from
flammable materials.
ATTENTION! Charging the battery improperly may damage it. Before inserting or removing
batteries, always disconnect the power cord plug from the socket (2).
Under no circumstances should you charge the batteries in an ambient temperature below 10 ° C or above
40 ° C.
•
•
Fully charge the battery up to 14 hours before the first use with the charger provided with the
device.
To charge, connect the DC end of the supplied power adapter to the battery
charging port (2) and plug the power cord into a power outlet.
•
•
It takes approximately 12 hours to fully charge the battery.
Full charging is signaled when the LED diode in the power supply changes its color from red to green.
•
•
The battery can be charged at any time and at any charge level.
The average working time is 6.5 hours and the maximum working time is up to 8 hours, depending on the strength of the pump.
M.BATTERY INSTALLATION
1. Open the battery door and pull out the power cables
2. Connect the cable marked (-) to the battery terminal marked (-) and then connect the
cable marked (+) to the battery terminal marked (+).
13