P.COOKING LIQUID, FILLING THE LIQUID TANK
When using chemical agents, always follow all safety rules given in this manual (especially safety
rules for contact with chemical plant protection products) and recommendations contained in the
instructions given by the manufacturer of the chemical agent.
Filling the liquid reservoir
Before filling the liquid tank, always make sure that the drain valve is in the closed position (lever at right angles to the drain hose). There is a liquid
level scale on the side of the tank to assist in filling and preparing spray liquid. The maximum capacity of the sprayer spray liquid tank is 16 or 20
liters (depending on the model). Never fill above the upper mark on the scale. Before filling the spray liquid tank, make sure that there is a sieve in
the filler opening. Its presence is necessary when filling the liquid reservoir. The sieve has filter holes with a diameter of 0.55 mm. If the sieve is
damaged, be sure to replace it with a new, original sieve, purchased from an authorized service center. Before filling the liquid tank, be sure to turn
off the sprayer pump, remove the sprayer from your back, place it on a firm surface and check that the liquid valve on the control handle is closed.
Do not overfill the liquid tank. The ground under the sprayer should be protected against liquid penetration into the ground or the sewage system
by placing a moisture-impermeable foil under the device. Remove any liquid spills immediately. After filling the liquid tank with the correct amount
of spray liquid, tighten the cap of the inlet hole to prevent any chemical leakage. The ground under the sprayer should be protected against the
ingress of liquid into the ground or the sewage system by placing a moisture-impermeable foil under the device. Remove any spills immediately.
After filling the liquid tank with the correct amount of spray liquid, tighten the cap of the inlet hole to prevent any chemical leakage. The ground
under the sprayer should be protected against liquid penetration into the ground or the sewage system by placing a moisture-impermeable foil
under the device. Remove any liquid spills immediately. After filling the liquid tank with the correct amount of spray liquid, tighten the cap nut
tightly to prevent chemical leakage.
Never prepare or store spray liquid in the sprayer tank.
Recommended volumes of the working liquid
When preparing the amount of the spray liquid, follow the recommendations of the chemical
manufacturer. Prepare a quantity of spray liquid according to the actual requirements.
General rules for selecting the amount of chemical plant protection products:
Plants near the ground - 0.3-0.5 l per 10 m2
Low bushes and shrubs - 1.0 - 1.5 l per 10 m2
Climbing plants, dense shrubs - 0.5 - 1.0 l each.
Large shrubs - 2.0 l each
Preparation of the working fluid
Chemical plant protection products only prepare in the open. They must not be prepared in closed
rooms, in places where food or feed is stored.
Plant protection products in the form of granules:
Prepare the working liquid in a separate container. Never use the sprayer tank for this. Mix well and
then pour it into the sprayer tank. It is essential to use an intraperitoneal strainer. You can use the
spray lance to move the liquid in the sprayer tank.
15
To Next Page
Loading...
