Liquid plant protection products:
Fill the sprayer liquid tank with 1/4 of the prescribed amount of water. In a
separate container, mix the chemical with water according to the
manufacturer's instructions. When pouring liquid into the tank, be sure to use
the strainer in the filling opening. Add the rest of the water according to the
chemical manufacturer's instructions. Using the sprayer lance, mix the liquid
in the sprayer tank.
Biological plant protection products:
After mixing, it is recommended to filter through a sieve before pouring the
sprayer liquid into the tank. This will prevent the strainer in the filler
opening from becoming clogged up quickly.
Identification of the chemicals used
To identify the containers with the chemicals used, you can use the
stickers attached to the sprayer, specifying the types of chemicals:
Herbizide - herbicides
Insektizide - insecticides
Fungizide - fungicides
IMPORTANT Never fill the fluid reservoir with any other type of chemical without first thoroughly
emptying any residual fluid and washing the fluid reservoir, pump, hoses, and lance. After washing
the tank, fill with water and run for a short time to thoroughly remove any residual fluid from the
pump, hoses, lance and nozzles. This will prevent the risk of hazardous chemical reactions between
substances.
P.BACKPACK BATTERY SPRAYER
Purpose of the sprayer
The battery pack sprayer is designed to spray approved pesticides, herbicides, insecticides,
fungicides and liquid fertilizers, available from authorized retailers. We recommend that you use
only agents approved for use by local regulations. Backpack pressure sprayers are widely used in
agriculture, horticulture, forestry, viticulture, forest nurseries, greenhouses (only with proper
ventilation).
Outlet nozzle, fluid flow
The flat fan nozzle (a) is standard equipment on the sprayer. The spacing and shape of the nozzles were
selected to obtain the largest possible spray area For this nozzle, within a certain range
pressure, the following flow rate is obtained:
Pump switch position Working fluid flow [l / min]
Setting up I
Setting up II
0.44
0.56
16
To Next Page
Loading...
