PowerMate
Operation Manua
MAINTENANCE AFTER EVERY YEAR OF OPERATION continued
13. Replace the Rubber End Cap on the bottom of the outer frame.
14. Remove and replace the two Push Buttons and Push Button Caps.
15. Check that all electrical wire connections are secure.
16. Check that the battery and battery charger are in good condition and that the
battery is fully charged.
17. Repeat the equipment load test from step #1. Cycle the equipment up and down
several times in order to evaluate its condition.
WARNING - All repairs, electrical or mechanical, should be carried out only by a
trained and competent service person. Use only approved repair
parts; any others may create a hazard.
PN 010680 Rev.E
Eng. 05/ 08/ 14
5.02
To Next Page
Loading...
Need help?
General
