3
27. Never leave the Lathe running unattended.
Turn the power off and do not leave the
machine until the spindle comes to a complete
stop.
28. Use proper extension cord. Make sure your
extension cord is in good condition. When using
an extension cord, use one heavy enough to
carry the current your product will draw. An
undersized cord will cause a drop in line voltage
resulting in loss of power and overheating. Sect.
7.2, Table 2 shows correct size to use
depending upon cord length and nameplate
ampere rating. If in doubt, use the next heavier
gauge. The smaller the gauge number, the
heavier the cord.
29. Never leave the Lathe running unattended.
Turn the power off and do not leave the
machine until the spindle comes to a complete
stop.
30. Remove loose items and unnecessary work
pieces from the area before starting the
machine.
31. Don’t use in dangerous environment. Don't use
power tools in damp or wet locations, or expose
them to rain. Keep work area well lighted.
32. Check the workpiece carefully for splits, knots
or other obstructions which may cause a safety
risk while turning.
33. Adjust the tool support to the proper height and
position for the work. Rotate the workpiece by
hand to check clearance with the tool support.
34. Select the appropriate speed for the turning job
at hand. Start at low speed and allow the Lathe
to ramp up to operating speed.
35. Never stop a rotating workpiece with your hand.
36. If gluing up a workpiece, always use a high-
quality glue of the type necessary for that
particular workpiece.
Familiarize yourself with the following safety notices used in this manual:
This means that if precautions are not heeded, it may result in minor injury and/or possible
machine damage.
This means that if precautions are not heeded, it may result in serious, or possibly even fatal,
injury.
SAVE THESE INSTRUCTIONS
1.1 Switch lockout
It is recommended that a padlock (not provided)
be used with the on/off switch atop the inverter, to
prevent unauthorized use of the machine.
Push switch to OFF, insert padlock through holes
and lock it. Store key in a safe place.
Figure 1-1
WARNING: This product can expose you to
chemicals including lead and cadmium which
are known to the State of California to cause
cancer and birth defects or other reproductive
harm, and phthalates which are known to the
State of California to cause birth defects or other
reproductive harm. For more information go to
http://www.p65warnings.ca.gov.
WARNING: Drilling, sawing, sanding or
machining wood products generates wood dust
and other substances known to the State of
California to cause cancer. Avoid inhaling dust
generated from wood products or use a dust
mask or other safeguards for personal
protection.
Wood products emit chemicals known to the
State of California to cause birth defects or other
reproductive harm. For more information go to
http://www.p65warnings.ca.gov/wood.
To Next Page
Loading...
