Cooling
the heat sink mounted sensors. This ensures that fan noise and
other, leave one rack unit empty every four to guarantee adequate
Cleaning
gripping the outermost silver panels and pull them outwards
Package list
OR
Signal Grounding
order to limit hum and/or interference entering the signal path, use
In the interests of safety, the unit MUST always operate with
electrical safety earth connected to the chassis via the dedicated
wire.
match the voltage of the input signal.
The Smart Rails Management technology implemented in the power
If the signal is missing for more than 30 minutes on all channels, the
save energy (Time out time is selectable via Armonía in DSP+D Versions). Normal
signal is detected.
dip switch on the rear panel.
Energy Save
rear panel.
DC
DC
triggers
DC
may damage the input
circuitry.
The couple of terminals act depending on the actual state of the
REMOTE ON REMOTE OFF AMPLIFIER STATE
Any Force Turn ON
Force Turn OFF
No Change
power.
switch on the rear panel.
Breaker Save
The remote level controls are in series with the level adjustment
Remote Level adjustment
3,81 5447900 connector.
AC
up to 240 V
AC
±10%.
the approved power cord is provided.
AC Mains Supply
EN
To Next Page
Loading...
Need help?
General
