powersoft M50Q - Removing the Heatsink; Detach Mosfets from Heatsink; Remove Heatsink from Board

INDEX
13
M SERIES | SERVICE MANUAL
8. Removing the heatsink:
Once the main board has been removed from the
amplier chassis as described in chapter 5, if necessary
it is possible to remove the heatsink in order to gain
access to the components placed underneath.
By means of a M5 socketed wrench, remove all the
springs retaining the mosfets to the heatsink as portrayed
in (Fig. 27)
Using a thin piece of hard plastic, gently pry the mosfets
off the heatsink in order to create a little gap as portrayed
in (Fig. 28)
It is now possible to remove the heatsink from the board
by simply carefully pulling on it vertically.
(Fig. 27)
(Fig. 28)