PowerTech MB3906 User Manual

10
MEMORY FUNCTION / RESET:
SWITCHING BETWEEN MODES:
After connection to mains, the charger automatically returns to the last
charge mode used. If the charger stays on “STANDBY” press the mode key.
Press the MODE selection button the appropriate number of times.
The device switches between charging modes in the following order for
12V battery:
Standby > MODE 1 > MODE 1 & 4 and >
MODE 2 > MODE 2 & 4 and > then repeats the cycle.
The device switches between charging modes in the following order for 6V
battery:
Standby > MODE 3 > MODE 3 & 4 and > then repeats
the cycle.
Long press 3 sec. the MODE selection button the appropriate number of
times. The device switches between charging modes in the following order:
Standby > MODE 5 > MODE 6 > then repeats
the cycle.
NOTE:
• MODE 5 : If voltage of the battery is out of 11.6-13.8V, Mode 5
is not available, will go to MODE 6 directly.
• MODE 6: Repair & Recover and charging the deeply discharged or
sulfated (desulfation) 12V batteries.
• If you press the selector button, charging mode automatically switches
over to the next mode and begins operation in that mode.

PowerTech MB3906 Specifications

General

Brand	PowerTech
Model	MB3906
Category	Battery Charger
Language	English