PowerVision PowerDolphin - Operations

Insert one end of the bait container connecting stick into the long slot at the bottom of
PowerDolphin and the other end into the semicircular hole in the front of the bait contain-
er, as shown in the figure. When the connecting stick is secured into place, the fitting pin at
the bottom of PowerDolphin and the fitting button on the bait container will tighten the
connecting stick automatically.
• Installation
Press and hold the Custom button on the remote controller or touch the Unhook/Bait
button in the App to execute the bait drop operation. When the operation is done,
the bait container will rotate for 180°, and its lid will open automatically. You can short press
the Custom button on the remote controller to reset the bait container.
• Operations
21