PowerVision PowerDolphin - Device Activation and Preparation; Starting Sailing

You need to activate a new PowerDolphin in the Vision+ 2 App by the following steps:
1. Connect the device.
2. Log in to the Vision+ 2 App.
3. Activate your device by following the instructions in the App.
Device Activation
34
After the device is activated successfully, make sure that your mobile device is
connected to the Internet and the App is running within 24 hours so that the acti-
vation code can be uploaded to the server in a timely manner. Otherwise, your
account will be logged out.
Before sailing, ensure the following:
1. The rubber plug at the microSD card slot is secured into place to prevent water damage.
2. The smart battery of the device is installed and secured into place.
3. The antennas of the device are unfolded and vertical, and the antennas of the remote
controller are at the best position for the best communication outcome.
4. There is no foreign object in the propellers and blades.
5. Whether it is necessary to lift the camera manual joint to help preview and capture
scenes above the water during sailing.
6. The device, remote controller, mobile device, and PowerSeeker have sufficient power.
7. PowerDolphin is connected to the Vision+ 2 App, and the power-on auto-check is
normal.
Sailing Preparations
Place PowerDolphin into the water and unlock it by using the App or remote controller,
then you can start sailing.
Start Sailing