Powerwerx DB-750X - VFO Frequency Linkage; Wide;Narrow Band; Cross Band Repeat; LCD Backlight

28
DB-750X
7
General Setting
Set the left band and right band as VHF (136-174 MHz) and
UHF (400-470 MHz), then turn on this function to enable Cross
Band Repeat. CAUTION: DO NOT EXCEED MID2 (10 WATT)
POWER LEVEL, AS THIS WILL VOID YOUR WARRANTY.
1.
Press key to enter function menu.
2.
Switch the selector knob to choose No. 44
function. The LCD displays "X-RPT".
3.
Press the main band selector knob. The
LCD displays "XSTART".
4.
Press the main band selector knob, the radio beeps and the LCD
displays "RPT". The cross band repeat function is on.
1.
Press key to enter function menu.
2.
Turn the main band selector knob to choose No. 45-47 menu. The
LCD displays "COL RED","COL GRN","COL BLU"
3.
Press the main band selector knob to
enter function setup.
4.
Switch the main band selector knob to
choose desired value.Each color (red,
green, blue) has 32 brightness levels.
5.
Press the main band selector knob or
key to store value and return to function
menu. Press
key or hold selector
knob for one second to store setup and
exit.
CROSS BAND REPEAT
LCD BACKLIGHT
1.
Press key to enter function menu.
2.
Turn the main band selector knob to
choose No. 43 menu. The LCD displays "WIDNAR".
3.
Press the main band selector knob to enter function setup.
4.
Switch the main band selector knob to choose desired value.
WIDE: Wide band (25 kHz)
MIDDLE: Middle band (20 kHz)
NARROW: Narrow band (12.5 kHz)
5.
Press the main band selector knob or
key to store value and return to function
menu. Press
key or hold selector
knob for one second to store setup and exit. Refer to Wide/Narrow
table in appendix.
WIDE/NARROW BAND
This function is only valid when both bands are on VFO mode.
Press
to turn off cross band function.
NOTE
NOTE
Enable this function to adjust VFO frequency, will bring same frequency
simultaneously for both bands. Adjust one knob, and the frequency for
both bands will increase or decrease one step size value.
1.
Press key to enter function menu.
2.
Turn the Main band selector knob to
choose No. 42 menu. The LCD displays "VFOTR".
3.
Press the main band selector knob to enter function setup.
4.
Switch the main band selector knob to choose desired value.
Available values: ON, OFF.
5.
Press the main band selector knob or
key to store value and return to function menu. Press
key or
hold selector knob for one second to store setup and exit.
VFO FREQUENCY LINKAGE