1
Powerwinch
712, 712-S, & 912 Trailer Winch
INSTALLATION
MOUNTING UNIT
The following instructions are for standard mounting of winch. Winch can be mounted on
trailer in same position and location as an existing hand winch.
1. Remove existing hand winch.
2. Position unit on trailer mount stand.
3.
in fully loaded position on trailer. If bow eye is too high, extra pull is required of winch
and extra stress is exerted on boat’s stern and bow eye.
If necessary to create equal height, raise or lower winch stand. In most cases,
trailer manufacturers have adapters available for use with a winch.
4.
when boat is in fully loaded position. If necessary, extend bow stop to obtain clearance.
5.
mounting holes do not line up with winch, use the bottom of winch as a template and
6.
as possible to base of winch. See illustration on page 3. Pulley block comes with
P77712 & P77912 only.
To Next Page
Loading...
