2
Powerwinch
712, 712-S, & 912 Trailer Winch
The following instructions are for permanently wiring the winch.
1. Attach circuit breaker to battery’s POSITIVE (+) post or positive (+) terminal of
starter solenoid.
2. Attach ground wire (black) to vehicle frame. Clean metal frame with a wire brush
furnished).
3. Route wire under vehicle and along the frame. Avoid sharp edges and moving
SHOCK HAZARD. ALWAYS disconnect battery before working on
electrical equipment.
ALWAYS use recommended wire size and rated circuit breakers.
hazard and void warranty.
NOTICE
NOTICE
When routing wiring, AVOID sources of heat.
When routing wiring, AVOID sharp edges that can cut or fray wire insulation.
60 amp
Circuit Breaker
12V Vehicle Battery
pwRC007
Red Wire
Black Wire
Secure Harness to Frame
Approximately Every 18”
WIRING UNIT
Attach Ground to
Vehicle Frame
Power Plug to Winch
Post of Vehicle Battery
To Next Page
Loading...
