Powtran PI500-S Series User Manual

Chapter 5 Function parameter
39
Chapter 5
F8.10
Auto reset times
0~32767
32767
☆
When the frequency converter chooses to reset the fault automatically, it is used to set the
number of automatic reset. After more than this frequency, the converter remains in a state of
failure.
When setting up the F8.10 automatic reset number larger than 1, the instantaneous power
converter, and power converter, automatic operation.
When the fault is reset automatically and the normal operation time is more than 1 hours, the
reset rate is reset.
F8.11
Fault DO action
No action
0
0
☆
action
1
If the inverter has set up the automatic reset function, the malfunction DO will be operated
during the automatic reset, and can be set via the F8.10.
F8.12
Fault reset interval
0.1s~100.0s
1.0s
☆
The wait time between the self alarm of the frequency converter and the reset of the automatic
fault.
F8.27
Instantaneous stop protection
voltage
50%~100%
80%
☆
F8.29
Momentary judgement voltage
50.0%~100.0%( Standard bus voltage)
80%
☆
F8.30
Off load protection options
Invalid
0
0
☆
Effective
1
F8.31
Load test level
0.0%~100.0%( Rated current of
motor)
10.0%
☆
F8.32
Load test time
0.0s~60.0s
1.0s
☆
If the off load protection function is valid, when the inverter output current is less than the
load detection level F8.31, and the duration is greater than the load detection time F8.32, the
output frequency of the inverter is automatically reduced to 7% of the rated frequency. During off
load protection, the inverter automatically returns to the set frequency if the load is resumed.
5-1-10.Communication parameterF9.00
Code
Parameter name
Setting range
Factory
setting
Change
Limit
F9.00
Baud rate
Units digit
MODBUS
6005
☆
300BPS
0
600BPS
1
1200BPS
2
2400BPS
3
4800BPS
4
9600BPS
5
19200BPS
6
38400BPS
7
57600BPS
8
115200BPS
9
Tens digit
Profibus-DP
115200BPS
0

Powtran PI500-S Series Specifications

General

Brand	Powtran
Model	PI500-S Series
Category	Inverter
Language	English