EasyManua.ls Logo

PPA Jet Flex - Technical Features; Tools Required for Installation; Electrical Installation

PPA Jet Flex
9 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4 5
TECHNICAL FEATURES
TOOLS REQUIRED FOR INTALLATION
Below are some of the tools required to install the operator:
ELECTRICAL INSTALLATION
For the electrical installation, the network must have the following characteristics:
- Electrical network of 127 V or 220 V.
- 5-A circuit breakers in the electrical power distribution box.
- 3/4” diameter conduits between the electrical power distribution box and the to-
tal shutdown device;
- 3/4” diameter conduits between the total shutdown device and the operator con-
nection point;
- 1/2” diameter conduits for external and optional pushbuttons;
- 1/2” diameter conduits for safety photocells (optional).
-The cable for xed wiring must comply with NBR NM 247-3.
-The power supply conductor of a product for internal use must
be a 3 x 0.75mm² exible cable, be 500 V and comply with the
NBR NM 247-5 standard.
-The power supply conductor of a product for external use must
be a 3 x 0.75 mm2 exible cable, be 500 V and comply with the
IEC 60245-57 standard.
NOTE: this product is manufactured with an M6 straight grease ni-
pple that facilitates the greasing of the inner crown, since it is not
necessary to disassemble the gearmotor to carry out maintenance,
which provides agility and practicality to installers.
PLIERS SAW BOW CANNON KEY SCREWDRIVER OPEN-END WRENCH
LADDER
WELDING MACHINE HAMMER LEVEL RULER METERING TAPE GREASE GUN
ANGLE RULER DRILL PENCIL SANDERS
TYPE OF GATE OPERATOR Sliding Sliding
MODEL Jet Flex Jet Flex
POWER SUPPLY 220 V 127 V
RATED FREQUENCY 60 Hz 60 Hz
RATED POWER 200 W 200 W
MOTOR RPM 5800 RPM 5800 RPM
RATED CURRENT 2,3 A 4,7 A
REDUCTION RATIO 1:40 1:40
LINEAR SPEED
24,7 m/min (Z12)
35 m/min (Z17)
24,7 m/min (Z12)
35 m/min (Z17)
CYCLES Continuous Continuous
PROTECTION RATING IPX4 IPX4
OPERATING TEMPERATURE -5° C / +50° C -5° C / +50° C
INSULATION SYSTEM Class B, 130° C Class B, 130° C
LIMIT SWITCH SYSTEM Hybrid Hybrid
MAX LEAF WEIGHT
1.500 Kg (Z12)
1.200 Kg (Z17)
1.500 Kg (Z12)
1.200 Kg (Z17)
MAX LEAF SIZE
Height: 2,5m
Length: 10,0m
Height: 2,5m
Length: 10,0m

Related product manuals